TM-9-2320-280-34

TRUCK, UTILITY: M998 SERIES

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

JANUARY 1996

TM-9-2320-280-34 - Page 431 of 1258

TM 9-2320-280-34

6-8. ENGINE WIRING HARNESS REPLACEMENT (Cont ’d)

49.

Install leads 74A (4) and 74B (2) on starter solenoid (1) with clip (5) and screw (6).

NOTE

Only harness lead 81B is connected to positive terminal for 6.5 L.

50.

Connect harness leads 81A (3), 81B (9), and 6A (10) to positive terminal (11) with lockwasher

(8) and nut (7). Using torque adapter, tighten nut (7) to 39 lb-ft (53 N

•

m).

51.

Install harness (16) on cylinder block (12) with clamp (13), lockwasher (14), and nut (15).

52.

Install harness (16) on bracket (17) with clamp (19), capscrew (18), and nut (20).

NOTE

Do not perform steps 53 and 54 if engine is removed from vehicle.

53.

Connect harness connector 315C (23) to transmission connector (22).

54

Install harness (16) on transmission (21) with clamp (24) and screw (25).

6-84