TM-9-2320-280-34
TRUCK, UTILITY: M998 SERIES
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
JANUARY 1996
TM-9-2320-280-34 - Page 929 of 1258
TM 9-2320-280-34
17-30.
TRANSMISSION ASSEMBLY FROM SUBASSEMBLIES (4L80-e) (Cont ’d)
7.
Determine correct apply pin to be used from table below:
NOTE
* Apply pins are identified by the number of rings around small end of
apply pins.
* If necessary to change apply pin, refer to rear servo repair para.
17-
27.
Table 17-7.
Apply Pin Selection
a.
If both flats are above gauge surface, use pin length #1.
b.
If one flat is above gauge surface, use pin length #2.
c.
If both flats are below gauge surface, rotate to side B.
d.
If both flats are above gauge surface, use pin length #3.
e.
If one flat is above gauge surface, use pin length #4.
f.
If both flats are below gauge surface, rotate to side C.
g.
If both flats are above gauge surface, use pin length #5.
h.
If one flat is above gauge surface, use pin length #6.
i.
If both flats are below gauge surface, use pin length #7.
8.
Remove checking tool and gauge pin.
17-143
Back to Top
