TM-9-2320-280-34

TRUCK, UTILITY: M998 SERIES

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

JANUARY 1996

TM-9-2320-280-34 - Page 922 of 1258

TM 9-2320-280-34

1 7 - 1 3 6

Change 1

1 7 - 3 0 . TRANSMISSION ASSEMBLY FROM SUBASSEMBLIES( 4 L 8 0 - E )

( C o n

t

’ d )

NOT E

• Soak all clutch plates in transmission fluid for at least three

minutes before assembly.

• Wave plate is used on 1997-1998 transmissions only.

1.

Install wave plate (5.1), four clutch plates (3), plate assemblies (5), and backing plate (2) on

transmission case (4) starting with a clutch plate (3), then alternating plate assemblies (5) with

clutch plates (3) and ending with flat side of backing plate (2) facing down.

2.

Secure backing plate (2) to transmission case (4) with snapring (1). Position snapring gap at

nine o’clock position.

3.

Measure gap between snapring (1) and backing plate (2). Gap should be 0.040-0.107 in.

(1.02-2.72 mm).

e. Intermediate Clutch Assembly

1 9 9 5 - 1 9 9 6

1 9 9 7 - 1 9 9 8