TM-9-2320-280-34

TRUCK, UTILITY: M998 SERIES

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

JANUARY 1996

TM-9-2320-280-34 - Page 952 of 1258

TM 9-2320-280-34

18 - 3.

TRANSFER CASE REPAIR (Model 218) (Cont ’d)

CAUTION

All bearings used in the transfer case must be correctly positioned

to avoid covering the bearing oil feed holes. After replacing any

bearing, check bearing position to be sure oil feed hole is not

blocked. Incorrect bearing installation will lead to failure of

transfer case.

10.

Inspect rear retainer output shaft bearing (1) for damage. If damaged, perform steps 11 and 12. If

not, go to step 13.

11.

Remove bearing (1) from rear retainer (2).

NOTE

Be sure shielded side of bearing faces interior of transfer case after installation.

12.

Using driver handle and rear retainer bearing installer, install bearing (1) in rear retainer (2).

13.

Inspect front output shaft front bearing (4) for damage. If damaged, perform steps 14 and 15. If not,

go to step 16.

14.

Using driver handle and front output shaft front bearing remover, remove bearing (4) from front

case (3).

18-12