TM-9-2320-283-13-P
ANTI-LOCK BRAKE SYSTEM (ABS) M915A1
TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL)
AUGUST 2012
TM-9-2320-283-13-P - Page 85 of 400
TM 9-2320-283-13&P
0013
0013-3/4 blank
SPECIAL INSTRUCTIONS-CONTINUED
WARNING
Compressed air source shall not exceed 30 psi (207 kPa). When
cleaning with compressed air, eye shields must be worn. Failure to
comply may result in injury to personnel. Seek medical attention in
the event of an injury.
CAUTION
To prevent contamination, do not clean internal surfaces of an hose,
valve, or fitting with cleaning solvent compound. Failure to comply
may result in damage to equipment.
NOTE
MIL-PRF-680 Type II and IV degreasing solvents shall be used as
degreasers and cleaners for painted and unpainted metal parts. These
two approved types of solvents are hydrocarbon-based, low-odor, and
recyclable. In addition Type II and IV have a high flash point and are
not defined as a flammable material. Type IV solvent contains citrus
odor and has a stronger solvency than Type II solvent. Used
MIL-PRF-680 solvent should not be mixed with other waste
materials, especially those containing halogenated solvents, and
disposal shall be in accordance with local, state, and Federal
regulations.
Keep it clean - Dirt, grease, oil, and debris get in the way and may cover up a serious problem. Clean work area
as needed. Use MIL-PRF-680 Type II or IV degreasing solvent to clean oil and grease from all exterior metal
surfaces of equipment. Use a soap and water solution to clean dirt and debris from all exterior and interior
surfaces and rinse thoroughly with clean water.
Bolts, nuts, and screws - Check them all for obvious looseness, missing, bent or broken condition. Look for
corrosion around bolt heads. If mounting hardware is loose, damaged, or corroded, notify Field Maintenance.
Wiring harness, wires, and connectors - Look for cracked or broken wiring. If damaged wiring or loose
connections are found, notify Field Maintenance.
END OF WORK PACKAGE
Back to Top
