TM-9-2320-283-20-2
TRUCK TRACTOR, LINE HAUL, 50,000 GVWR, 6X4, M915A1
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE PART 2 OF 3
DECEMBER 1983
TM-9-2320-283-20-2 - Page 514 of 852
TM 9-2320-283-20-2
FRONT AXLE.
3-149.
STEERING KNUCKLE ASSEMBLY REPLACEMENT.
LOCATION/ITEM
ACTION
REMARKS
B.
CLEANING AND INSPECTION
12. All parts.
Clean and inspect.
Refer to paragraphs 3-4
and 3-5.
C.
INSTALLATION.
13. Two new bushings
a.
Lightly lubricate with
(3).
grease.
b.
Start in item (23) by
hand.
c.
Drive into item (23) with
bushing driver and a brass
hammer until mark on dri-
ver is flush with item
(23).
14. New seal (9).
a.
Lightly lubricate with
grease.
b.
Install in item (23) with
bushing driver and a brass
hammer.
15. Axle beam (15) and
Lightly lubricate machined
knuckle assembly
surfaces with grease.
(23).
16. New thrust pack
Put on item (23).
Rubber side faces down.
(14).
17 New pin (20).
Put in item (23) from bottom
Be sure end marked "top"
until just flush with item
faces up.
(14).
18. Knuckle assembly
Put in place on item (15).
(23).
19. Pin (20).
a.
Line up flat with hole for
item (16).
b.
Drive halfway into item
(15).
3-886
Back to Top
