TM 9-2320-283-34-1
ELECTRICAL SYSTEM.
3-21.
ALTERNATOR AND RECTIFIER REPAIR (Continued).
LOCATION/ITEM
ACTION
REMARKS
E.
ASSEMBLY.
26. Slipring housing
assembly (23).
NOTE
If slipring bearing was not removed,
go to step lld.
a. Place item (23) on press
with rear of housing fac-
ing up.
b. Place item (24) with seal
Bearing is properly in-
facing downward on hous-
stalled when the manu-
ing.
Carefully press
facturer's part number
bearing into housing until
is facing upward.
bearing is seated on lip
inside housing bore.
c. After bearing is installed,
apply a small amount
of grease to rollers.
3-138