TM 9-2320-283-34-1
TRANSMISSION.
3-44.
ADAPTER HOUSING REPAIR (Continued).
LOCATION/ITEM
ACTION
REMARKS
D.
ASSEMBLY (Continued).
4
Housing (8) (continued)
i. Lubricate item (5) and item (6)
Use OE/HDO-1O lubricating oil.
j. Install item (5) into
Lip of seal must face
groove inside item (4)
away from spring side of piston.
k. Install item (6) into
Lip of seal must face
outside groove of item (4).
away from spring side of piston.
l. Place item (8) with piston
cavity facing upward.
m. Apply a generous amount of
OE/HDO-1O lubricating oil
into piston cavity of item (8).
n. Install item (4) into
Retaining ring of piston
cavity of item (8)
must face away from adapter
housing.
NOTE
Use care to prevent lips of seals folding back during assembly.
If installation is difficult,
remove piston and check seal and cavity bore before attempting assembly again.
o. Store assembly in a clean dry place.
NOTE
Follow-on maintenance action required:
Proceed with transmission maintenance.
3-432