TM 9-2320-283-34-2
Section IX. BRAKE SYSTEM
This section provides procedures authorized
maintenance levels to adjust, replace,
at direct and general support
and repair brake sytem components.
To
find a specific procedure
below.
contained in this section, see the task summary
3-78. TASK SUMMARY.
INITIAL SETUP
All.
APPLICABLE CONFIGURATIONS
EQUIPMENT CONDITION
PARAGRAPH
CONDITION DESCRIPTION
(Refer to specific paragraph for this
TEST EQUIPMENT
Gage, air pressure, 0-200 psi
SPECIAL TOOLS
None.
MATERIALS/PARTS (P/N)
Paint
Item 25, Appendix B.
Oil, lubricating: OE/HDO 30
Item 17, Appendix B.
Rags, wiping
Item 26, Appendix B.
Solvent, drycleaning, SD-2
Item 31, Appendix B
Grease, pneumatic
Item 10, Appendix B.
Tape, thread sealing
Item 35, Appendix B.
Preformed packing
(06853) 239898.
PERSONNEL REQUIRED
Two (MOS-63W).
SPECIAL ENVIRONMENTAL CONDITIONS
Work area clean and away from blowing
dirt and dust.
O-ring
(06853) 238327.
Preformed packing
(06853) 232068.
Preformed packing
(06853) 231159.
Gasket
(06853) 240457.
Kit, brake valve repair
(06853) 289352.
Lining (2)
(52304) 5731471.
Lining (2)
(52304) 5731493.
Rivet (52)
(52304) 5731473.
Diaphragm (2)
(50153) 1126M009.
O-ring
(50153) 11M114
Governor gasket
(06853) 237202.
O-ring (2)
(06853) 239658.
O-ring (2)
(06853) 230175.
REFERENCE (TM)
TM 9-2320-283-10.
TM 9-2320-283-20.
TM 9-2320-283-34P.
GENERAL SAFETY INSTRUCTIONS
Block rear wheels.
TROUBLESHOOTING REFERENCES
Paragraph 2-7.
3-732