TM-9-2320-283-34-2
TRUCK TRACTOR, LINE HAUL, 50,000 GVWR, 6X4, MQ15A1
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
DECEMBER 1983
TM-9-2320-283-34-2 - Page 272 of 570
TM 9-2320-283-34-2
STEERING SYSTEM.
3-93. STEERING GEAR REPLACEMENT (Continued).
LOCATION/ ITEM
ACTION
REMARKS
C. INSTALLATION (Continued).
13. Two nuts (16) and
Install on items (3).
Screw in until snug, but
washers (2).
do not tighten. Assist-
ant is no longer needed
after this step.
14. Two bolts (3) and
Install into items (14) and
Torque all four items
(15), washers (2), (1).
(16) to 260-280 1b-ft.
and nuts (16).
15. Yoke (8).
Install onto shaft on end of
item (14).
16. Capscrew (7).
Install into item (8).
Torque item (5) to 35
lockwasher (6),
lb-ft.
and nut (5).
17. Arm (11).
a. Drive a wedge into slot
to open it up slightly.
b. Rotate item (8) until
alinement marks (12) on
item (11) and shaft of
item (14) line up.
c. Using a soft faced hammer,
tap item (11) onto shaft
of item (14).
d. When item (11) has been
properly installed, remove
wedge.
18. Bolt (13) and
nut (10).
Install into item (11).
NOTE
Torque item (10) to 380-
420 lb-ft.
Follow-on maintenance action required:
Fill and bleed steering system
(TM 9-2320-283-20).
If steering gear is new or repaired,
adjust poppet valves (para 3-92).
3-828
Back to Top
