TM-9-2320-304-14-P

LOAD HANDLING SYSTEM, HEAVY EXPANDED MOBILITY TACTICAL TRUCKS (HEMTT)

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, AND DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

AUGUST 2000

TM-9-2320-304-14-P - Page 230 of 1320

TM 9-2320-304-14&P

2-82.82

Operating Instructions (Cont)

2-10.4 LOADING AND UNLOADING CONTAINER (51 INCHES [130 CM] OR TALLER)

TO TRUCK USING FRONT LIFT ADAPTER (FLA) (CONT).

NOTE

Engine speed may be increased and decreased to ease loading.

(45)

After container (6) contacts rear sliders (21), increase engine speed to approximately 1500 rpm

until container is almost loaded. Reduce engine speed to idle.

CAUTION

After loading operations using CHU kit and container and the LHS NO TRANSIT indicator

goes off, operator must release the joystick from the LOAD position. Failure to release the

joystick may cause LHS OVER LOAD indicator to illuminate and hydraulic cylinders to

remain active, forcing a temporary bow in the LHS frame, resulting in contact between

LHS and container.

(46)

Continue loading until container (6) is fully loaded and LHS NO TRANS lamp (27) goes out.

(47)

Release joystick (10).

(48)

Pull out parking brake knob (3) to apply parking brake.

CAUTION

•

Engine speed must be at idle before using hydraulic selector switch, or damage to

equipment may result.

•

Hydraulic selector switch must be in the OFF position before driving truck, or

hydraulic system could overheat.

(49)

Turn hydraulic selector switch (9) to OFF.

(50)

Put PTO switch (7) in OFF position. Make sure indicator light (8) goes off.

(51)

Shut off engine (TM 9-2320-279-10).

Change 3