TM-9-2320-304-14-P

LOAD HANDLING SYSTEM, HEAVY EXPANDED MOBILITY TACTICAL TRUCKS (HEMTT)

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, AND DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

AUGUST 2000

TM-9-2320-304-14-P - Page 693 of 1320

TM 9-2320-304-14&P

4-234.21

Organizational Maintenance Instructions (Cont)

WARNING

Adhesives, solvents, and sealing

compounds can burn easily, can give off

harmful vapors, and are harmful to skin

and clothing. To avoid injury or death,

keep away from open fire and use in

well-ventilated area. If adhesive, solvent,

or sealing compound gets on skin or

clothing, wash immediately with soap and

water.

(3)

Apply a light coat of antiseize to outer

surface of bearing (7).

(4)

Install bearing (7), spacer (8), and

retaining ring (9) in short strut (10).

NOTE

•

Model A short strut has grease fitting on ring support end only. Model B has grease

fitting and plug on ring support end.

•

Install grease fitting and plug on Model B ring support end as noted prior to removal.

Grease fitting on Model B ring support end is installed so grease fitting faces towards

outside of vehicle.

(5)

Install grease fitting (11) and plug (11.1) in short strut (10).

(6)

Apply sealing compound to threads of screw (12).

(7)

Install spring (13), washer (14), washer (15), and screw (12) on short strut (10).

e. Installation.

WARNING

Adhesives, solvents, and sealing

compounds can burn easily, can give off

harmful vapors, and are harmful to skin

and clothing. To avoid injury or death,

keep away from open fire and use in

well-ventilated area. If adhesive, solvent,

or sealing compound gets on skin or

clothing, wash immediately with soap and

water.

NOTE

There are two pin bracket assemblies.

Both are installed the same way. Right

side is shown.

(1)

Apply sealing compound to threads of

four screws (1).

(2)

Install four screws (1) and pin

bracket (2) on arm assembly (3).