TM-9-2320-304-14-P

LOAD HANDLING SYSTEM, HEAVY EXPANDED MOBILITY TACTICAL TRUCKS (HEMTT)

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, AND DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

AUGUST 2000

  TM-9-2320-304-14-P - Page 684 of 1320

TM 9-2320-304-14&P
4-234.12
Organizational Maintenance Instructions (Cont)
4-53.2 CONTAINER HANDLING UNIT (CHU) SLIDER/PIVOT ASSEMBLY REPAIR
(CONT).
NOTE
Make sure retaining ring is fully seated in
step (3).
(3)
Soldier A and Soldier B position slider
pivot pin (2) in arm assembly (5) and
install spacer (3) and retaining ring (4).
(4)
Remove lifting device from slider
assembly (1).
(5)
Check that pivot lock pin (6) properly
locks into handle (7).
NOTE
If pivot lock pin does not properly lock into
handle, perform steps (6) through (9).
(6)
Remove four screws (8) and handle (7)
from arm assembly (5).
WARNING
Adhesives, solvents, and sealing
compounds can burn easily, can give off
harmful vapors, and are harmful to skin
and clothing. To avoid injury or death,
keep away from open fire and use in
well-ventilated area. If adhesive, solvent,
or sealing compound gets on skin or
clothing, wash immediately with soap and
water.
(7)
Apply sealing compound (loctite 242) to
threads of four screws (8).
Change 1


Back to Top