TM-9-2320-328-13-P-2

HEMTT-BASED WATER TENDER (HEWATT)

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST); PART 2 OF 3

MARCH 2009

TM-9-2320-328-13-P-2 - Page 1150 of 1390

TM 9-2320-328-13&P-2

0298-2

DRAFT

0298

Change 1

REMOVAL

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

NOTE

•

Perform Steps (1) through (13) to remove upper passenger side body wire harness.

•

Tag and mark wires prior to removal to ensure proper installation.

•

Note routing of upper passenger side body wire harness prior to removal to ensure proper

installation.

•

Note position and remove cable ties, split loom, and cushion clips as required.

1.

Disconnect upper passenger side body wire harness connector (1) from water level probe adapter (2).

2.

Disconnect upper passenger side body wire harness connector (3) from foam level probe adapter (4) and

route passenger side body wire harness (5) into top front passenger side stowage compartment (6).

HWT3399

..

..

..

..

..

..

..

..

..

..

..

..

..

CAUTION

Both water level probe adapter and foam level probe adapter are connected

to upper passenger side body wire harness and must be covered with heat

shrink tubing.

Failure to comply will allow moisture to enter connector ends

and not allow foam and water level gauges to function properly.