OPERATOR MAINTENANCE
DRIVE VEHICLE IN REVERSE
INITIAL SETUP:
Not Applicable
PREPARE VEHICLE
1.
Remove and stow wheel chocks.
2.
Adjust air-ride seat and mirrors as needed. (WP 0075)
3.
Adjust four-point seatbelt as needed. (WP 0076)
4.
Start engine. (WP 0044)
5.
Turn on lights as required.
DRIVE VEHICLE IN REVERSE
WARNING
Do not press service brake treadle hard three or four times in a row. Air
supply will be used up and service brakes will not work until air is built up
again. Failure to comply may result in injury or death to personnel.
1.
Make sure both (FRONT and REAR) air pressure gauges (1) read at least 100 psi (7
bar) before driving vehicle.
TM 9-2320-338-10
0051
0051-1