TM-9-2320-338-10

NOTE

If winch cable is connected to another vehicle, refer to Connect/Discon-

nect Self-Recovery Winch Cable to Another Vehicle (WP 0086) for dis-

connecting procedures.

52. Disconnect winch cable (9) from heavy object.

53. If snatch block was used, disconnect end of winch cable (9) from vehicle. (WP 0086)

Remove snatch block from winch cable (WP 0085) and tree, another vehicle, or heavy

object refer to FM 4-30.31. (WP 0160)

CAUTION

Do not reel clevis end of winch cable through roller guides. Clevis may

catch on roller guide and cause cable or roller guide to break.

54. Set PTO ENGAGE switch (2) to ON position. Indicator light (3) will illuminate.

55. Set HYD ENABLE switch (2) to on position. MAIN HYD ENABLE indicator (3) will

illuminate.

56. Set winch shift lever (4) to IN.

57. When end of cable is near rear of vehicle, release winch shift lever (4) to center position.

58. Set PTO ENGAGE switch (2) to OFF position. Indicator light (3) will go out.

59. Set HYD ENABLE switch (2) to off position. MAIN HYD ENABLE indicator (3) will go

out.

WARNING

•

Always wear protective gloves when handling winch cable. Never let

cable run through hands. Frayed cables can cut severely. Failure to

comply may result in injury or death to personnel.

•

Never operate winch with less than five wraps of cable on winch

drum. Failure to comply may result in injury or death to personnel.

60. Pull clevis (7) end of winch cable (9) forward through roller guide (13) and hole (12) in

fender.

TM 9-2320-338-10

0084

0084-42

TM-9-2320-338-10 - Page 546 of 1120