TM-9-2320-342-10-1
TRUCK, WRECKER, 8X8 M984A4
TECHNICAL MANUAL; OPERATOR'S MANUAL
OCTOBER 2008
TM-9-2320-342-10-1 - Page 1153 of 1428
PREPARE CRANE FOR OPERATION - Continued
9.
Set POWER switch (7) to ON position.
10.
Set HIGH IDLE CONTROL switch (8) to CRANE position.
11.
Push and release LATCH switch (9). Engine speed will increase to approximately
1500 rpm.
SETUP OUTRIGGERS
WARNING
•
Chock front wheels when using outriggers to prevent vehicle from
rolling. Failure to comply may result in injury or death to personnel.
•
Stand clear of outrigger beams while operating lever. Failure to
comply may result in injury or death to personnel.
NOTE
•
Always operate control levers with light, even pressure.
•
Outrigger beams can only be extended/retracted from controls on
same side of vehicle.
•
Outrigger beams will come out slower with light pressure on lever.
Pushing lever to full travel will cause faster movement.
•
Either right or left outrigger may be extended first, for the purposes
of this procedure; the right side is extended first.
1.
Move O/R EXT control lever (1) to IN position briefly and lift and turn right outrigger
lockpin (2) to unlock position.
TM 9-2320-342-10-1
0102
0102-5
Back to Top
