TM-9-2320-342-10-1
TRUCK, WRECKER, 8X8 M984A4
TECHNICAL MANUAL; OPERATOR'S MANUAL
OCTOBER 2008
TM-9-2320-342-10-1 - Page 713 of 1428
HOOKUP - Continued
•
Ensure all rigging is secure. Loose rigging can become entangled.
Failure to comply may result in damage to equipment.
NOTE
Operator must allow wrecker air suspension system to completely adjust
for added weight of disabled vehicle before raising disabled vehicle to
final height of 1 ft. (30 cm).
46.
Push in LIFT CYLINDER control lever (6) to retract lift cylinder (43) to raise disabled
vehicle approximately 3 in. (8 cm) off ground.
a.
Once wrecker air suspension system has adjusted for added weight of disabled
vehicle, push LIFT CYLINDER control lever (6) to retract lift cylinder (43) and
raise disabled vehicle to final height of 1 ft. (30 cm).
6
43
Figure 18.
47.
Adjust slack in two 16 ft. (5 m) safety chains so lengths between cross tube and
wrecker are approximately 1 ft. (30 cm) off ground.
48.
Set POWER switch (42) to OFF position.
TM 9-2320-342-10-1
0069
0069-15
Back to Top
