TM-9-2320-343-10

TRUCK, CARGO, 8X8 M985A4 W/WINCH AND M985A4 W/O WINCH

TECHNICAL MANUAL; OPERATOR'S MANUAL

OCTOBER 2008

TM-9-2320-343-10 - Page 1031 of 1128

4

Figure 4.

5.

Install two wheel chocks (WP 0072) (4) in front of and behind tire across (on same axle)

from tire and wheel assembly which is being removed.

CAUTION

Jack placement is critical to avoid damaging vehicle suspension compo-

nents. Follow jack placement notes and procedures carefully. Failure to

comply may result in damage to equipment.

NOTE

•

Jack ram should be fully screwed down (making jack as short as

possible) for Step (6).

•

Center jack on apex, 12 in. (30 cm) from end of equalizing beam.

6.

Position jack base plate (1) and jack (2) under apex of equalizing beam (3).

TM 9-2320-343-10

0152

0152-5