TM-9-2320-343-10
TRUCK, CARGO, 8X8 M985A4 W/WINCH AND M985A4 W/O WINCH
TECHNICAL MANUAL; OPERATOR'S MANUAL
OCTOBER 2008
TM-9-2320-343-10 - Page 443 of 1128
9
10
6
5
Figure 16.
7.
Unscrew jack ram (10) until it contacts transverse beam end casting (9), or is at full
extension.
NOTE
If axle cannot be jacked close enough to axle stop (2 in. [5 cm] or less)
to effectively install limp home setup, discontinue procedure and arrange
for vehicle recovery.
8.
Raise vehicle until axle (2) is as close as it will go to axle stop (3).
TM 9-2320-343-10
0077
0077-13
Back to Top
