TM-9-2320-343-10
TRUCK, CARGO, 8X8 M985A4 W/WINCH AND M985A4 W/O WINCH
TECHNICAL MANUAL; OPERATOR'S MANUAL
OCTOBER 2008
TM-9-2320-343-10 - Page 522 of 1128
46. Check that winch cable (9) is not caught on vehicle or any other objects.
WARNING
Keep all personnel clear of area near winch cable when tension is on
cable. Failure to comply may result in injury or death to personnel.
47. Ensure all personnel are clear of self-recovery winch (10) and winch cable (9).
48. Set PTO ENGAGE switch (2) to ON position. Indicator light (3) will illuminate.
49. Set HYD ENABLE switch (2) to on position. MAIN HYD ENABLE indicator (3) will
illuminate.
50. Move winch shift lever (4) to IN until slack is out of cable.
51. Release winch shift lever (4) to center position.
WARNING
Keep all personnel clear of area near winch cable when tension is on
cable. Failure to comply may result in injury or death to personnel.
CAUTION
•
Self-recovery winch is not designed to winch mired vehicle by itself.
Mired vehicle drive system power must always be used with winch to
self-recover vehicle, or damage to equipment may result.
•
If winch does not move mired vehicle, stop using winch, overheat
damage may result.
52. Ensure TRANSFER CASE shift lever (23) is set to LO.
TM 9-2320-343-10
0084
0084-16
Back to Top
