TM-9-2320-344-10

TRUCK, CARGO, GUIDED MISSILE TRANSPORTER (GMT), 8X8, M985A4GMT

TECHNICAL MANUAL; OPERATOR'S MANUAL

OCTOBER 2008

TM-9-2320-344-10 - Page 270 of 1012

CAUTION

Continuous crane operation for extended periods of time may cause

hydraulic oil to overheat. Extended periods of high idle with PTO pump

engaged can also cause overheating. If controls start to stick in open

position or if overheating is suspected, discontinue crane operations,

shut off PTO pump, and notify your supervisor. Failure to comply may

result in damage to equipment.

NOTE

The operator is able to use the controls one at a time or in pairs to

move the hook or load to the desired position.

b.

Read and carefully follow the above warnings, cautions, and notes for crane

operation.

NOTE

In remote operation, the crane is operated via the remote-control unit

which is connected to one of two available positions by the remote-control

cable.

3.

Remote (Remote-Control Unit) Operation.

a.

Perform remote operation-specific preparation for use procedures before setting

up the remote-control unit:

(1) Set ENGINE HIGH IDLE ON/OFF switch (1) to OFF position to decrease

engine rpm to idle.

TM 9-2320-344-10

0036

0036-28