TM-9-2320-346-10

TRUCK, COMMON BRIDGE TRANSPORT (CBT), 8X8 M1977A4 W/WINCH AND M1977A4 W/O WINCH

TECHNICAL MANUAL; OPERATOR'S MANUAL

OCTOBER 2008

TM-9-2320-346-10 - Page 1078 of 1184

•

This procedure is not applicable when removing wheel and tire

assembly for maintenance purposes and installing same wheel and

tire assembly on vehicle:

If wheel and tire assembly to be removed and reinstalled is on No. 1

or No. 2 axle, refer to remove wheel and tire assembly from No. 1 or

No. 2 axle.

If wheel and tire assembly to be removed and reinstalled is on No. 3

or No. 4 axle, refer to remove wheel and tire assembly from No. 3 or

No. 4 axle.

1.

Lower tire carrier. (WP 0035)

2.

With spare wheel and tire assembly resting on ground, remove four spare wheel and

tire assembly retention screws (1) from tire carrier mounting bracket (2).

2

1

Figure 1.

3.

While assistant steadies spare wheel and tire assembly, lower tire carrier (WP 0035)

until completely clear of spare wheel and tire assembly.

4.

With aid of an assistant, roll spare wheel and tire assembly to vehicle near flat wheel

and tire assembly, and lean spare wheel and tire assembly against vehicle.

5.

Check spare wheel and tire assembly air pressure.

6.

Service spare wheel and tire assembly as required. (WP 0155)

END OF TASK

TM 9-2320-346-10

0152

0152-2