TM-9-2320-346-10
TRUCK, COMMON BRIDGE TRANSPORT (CBT), 8X8 M1977A4 W/WINCH AND M1977A4 W/O WINCH
TECHNICAL MANUAL; OPERATOR'S MANUAL
OCTOBER 2008
TM-9-2320-346-10 - Page 255 of 1184
OPERATOR MAINTENANCE
OPERATE AIR SUSPENSION BALL VALVES
INITIAL SETUP:
Not Applicable
TURN BALL VALVES ON
CAUTION
•
Never operate vehicle with suspension dumped (deflated) during
normal driving operations. Failure to comply may result in damage to
equipment.
•
Never operate vehicle with one or more ball valves positioned OFF.
Failure to comply may result in damage to equipment.
NOTE
•
Vehicle is equipped with four ball valves, one on top of each air spring
on No. 1 and No. 4 axles. Each ball valve controls two air springs
(zone).
•
No. 1 axle driver side ball valve controls both No. 1 and No. 2 axle
air springs (zone) for that side of vehicle.
•
No. 1 axle passenger side ball valve controls both No. 1 and No. 2
axle air springs (zone) for that side of vehicle.
•
No. 4 axle driver side ball valve controls both No. 4 and No. 3 axle
air springs (zone) for that side of vehicle.
•
No. 4 axle passenger side ball valve controls both No. 4 and No. 3
axle air springs (zone) for that side of vehicle.
1.
Position ball valve (1) ON (shown):
a.
Pull lock (2) towards handle (3) and push handle (3) in until parallel with ball valve
(1).
TM 9-2320-346-10
0037
0037-1
Back to Top
