NOTE
Dashboard parking brake indicator will illuminate when PARKING
BRAKE control is applied.
18. Pull out PARKING BRAKE control (1) or apply service brake pedal (2).
19. Remove lockpin (20), pin (21), and bail bar lock (22) from LHS hook (23).
20. Move joystick (19) to UNLOAD.
21. Release joystick (19) when LHS hook (23) is slightly below BAP hook bar (24).
NOTE
•
If LHS hook does not disengage, drive vehicle forward approximately
two inches (5 cm) and repeat Steps (21) and (22).
•
Dashboard parking brake indicator will extinguish when PARKING
BRAKE control is released.
22. Push in PARKING BRAKE control (1) or release service brake pedal (2).
23. Drive forward slowly about 5 ft. (1.5 m) to clear LHS hook (23) from BAP hook bar (24).
Stop vehicle.
NOTE
Dashboard parking brake indicator will illuminate when PARKING
BRAKE control is applied.
24. Pull out PARKING BRAKE control (1) , set transmission range selector (3) to N (neutral).
25. Set HIGH IDLE switch (18) to on position.
26. Move joystick (19) to LOAD position.
WARNING
When NO TRANSIT indicator is illuminated, vehicle may be maneuvered
in the immediate vicinity of the loading/unloading site. However, vehicle
is unsafe for road travel. Do not perform open-road driving when NO
TRANSIT indicator is illuminated. Failure to comply may result in injury
or death to personnel and damage to equipment.
27. Release joystick (19) when main frame and hook arm are fully stowed and NO TRANSIT
indicator (25) is off.
TM 9-2320-346-10
0039
0039-12