TM-9-2320-361-20

2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; UNIT MAINTENANCE

OCTOBER 1991

TM-9-2320-361-20 - Page 347 of 1207

TM 9-2320-361-20

3-26. FUEL PUMP (IN-TANK) MAINTENANCE (Contd)

c. Disassembly

1.

2.

3.

4.

5.

6.

7.

8.

9.

10.

11.

12.

13.

3-44

Remove lead seal (9) from stud (33) by cutting wire. Discard lead seal (9).

Remove three nuts (5), lockwashers (4), locktab (10), and terminal cover (3) from plate and

bracket (32). Discard locktab (10).

Remove screw (1) and disconnect pump wire (27) from terminal cover (3).

Remove fuse (2) from terminal cover (3).

Remove nut (6), lockwasher (7), fuel pump wire (27), wire retainer (26), and gasket (8) from plate

and bracket (32). Discard lockwasher (7) and gasket (8).

Remove gasket (30) and recessed washer (29) from wire retainer (26). Discard gasket (30).

NOTE

Note location of mounting hardware on plate and bracket for

proper installation.

Remove nut (15), washer (16), screw (14), and clamp (31) from wire retainer (26) and plate and

bracket (32).

Remove pump (25) from clamp assembly (28).

Remove two nuts (15), washers (16), screws (14), and clamp assembly (28) from plate and bracket (32).

Remove two nuts (23), screws (20), four lockwashers (21), and ground strap (22) from pump (25) and

clamp assembly (28). Discard lockwashers (21).

Remove elbow (11) from plate and bracket (32).

Remove hose assembly (19), nut (18), lockwasher (17), “O” ring (13), and fitting (12) from plate and

bracket (32). Discard lockwasher (17) and “O” ring (13).

Remove clamp (24) and hose assembly (19) from pump (25).