TM-9-2320-361-20

2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; UNIT MAINTENANCE

OCTOBER 1991
TM-9-2320-361-20

  TM-9-2320-361-20 - Page 86 of 1207

TM 9-2320-361-20
CHAPTER 2
SERVICE AND TROUBLESHOOTING INSTRUCTIONS
Section I.
Repair Parts, Special Tools, TMDE, and Support Equipment (page 2-1)
Section II.
Service Upon Receipt (page 2-1)
Section III.
Preventive Maintenance Checks and Services (PMCS) (page 2-2)
Section IV.
Mechanical Systems Troubleshooting (page 2-24)
Section V.
Compressed Air and Brake System Troubleshooting (page 2-52)
Section VI.
Electrical Systems Troubleshooting (page 2-74)
Section VII. STE/ICE Troubleshooting (page 2-148)
Section I. REPAIR PARTS, SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT
2-1. COMMON TOOLS AND EQUIPMENT
For authorized common tools and equipment, refer to the Modified Table of Organization and Equipment
(MTOE) applicable to your unit.
2-2. SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT
Special Tools, Special Test, Measurement, and Diagnostic Equipment (TMDE), and Support Equipment used
to maintain the vehicles covered in this manual can be found in TM 9-2320-361-20P.
2-3. REPAIR PARTS
Repair parts covering unit maintenance are listed and illustrated in the Repair Parts and Special Tools List
(TM 9-2320-361-20P).
Section Il. SERVICE UPON RECEIPT
2-4. GENERAL
a.
Upon receipt of a new, used, or reconditioned vehicle, you must determine if the vehicle has been
properly prepared for service. The following steps should be performed:
(1)
Inspect all assemblies, subassemblies, and accessories to be sure they are in proper working
order.
(2)
Secure, clean, lubricate, or adjust as needed.
(3)
Check all Basic Issue Items (TM 9-2320-361-10) to be sure every item is present, in good
condition, and properly mounted or stowed.
(4)
Follow general procedures for all service and inspections given in TM 9-2320-361-10.
b.
The operator will assist when performing service upon receipt inspections.
c.
Refer to TM 9-2320-361-10 when testing equipment for proper operation.
2-5. GENERAL INSPECTION AND SERVICING INSTRUCTIONS
The following steps should be taken while performing general inspection and services:
(1)
Use TM 9-2320-361-10 and LO 9-2320-209-12-1, as well as other sections of this manual, when
servicing and inspecting equipment.
2-1


Back to Top