TM-9-2320-361-20
2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; UNIT MAINTENANCE
OCTOBER 1991
TM-9-2320-361-20 - Page 929 of 1207
12-90.
TM 9-2320-361-20
This task covers:
a. Removal
d. Assembly
b. Disassembly
e. Installation
c. Cleaning and Inspection
INITIAL SETUP:
APPLICABLE MODELS
REFERENCES (TM)
M764
TM 9-2320-361-10
MATERIALS/PARTS
Four locknuts
Two woodruff keys
GM grease (Appendix C, Item 13)
Drycleaning solvent (Appendix C, Item 26)
PERSONNEL REQUIRED
Two
TM 9-2320-361-20P
EQUIPMENT CONDITION
Parking brake set (TM 9-2320-361-10).
GENERAL SAFETY INSTRUCTIONS
Keep fire extinguisher nearby when using
drycleaning solvent.
NOTE
Forward and rear universal joints are removed the same way. This
procedure covers the rear universal joint.
1.
Loosen two setscrews (7) on universal joint (9).
NOTE
Assistant will help with steps 2 through 4.
2. Remove four locknuts (2) and screws (4) from bracket (1) and pump (3).
3. Lower pump (3) and remove pump shaft (5) from universal joint (9).
4. Install pump (3) with two screws (4) and locknuts (2). Do not tighten locknuts (2). Discard
remaining locknuts (2).
5. Remove universal joint (9) and two woodruff keys (6) from driveshaft (8). Discard woodruff keys (6).
Remove two clips (10) and boot (11) from universal joint (9).
WARNING
Drycleaning solvent is flammable and will not be used near open
flame. Use only in well-ventilated places. Failure to do so may
result in injury or death to personnel.
1. Clean all parts in drycleaning solvent and air dry.
2. Inspect parts for breaks, bends, cracks, burrs, scoring, and proper fit. Replace damaged parts.
3. Pack boot (11) with GM grease and apply a light coat to both ends of universal joint (9).
Install boot (11) and two clips (10) on universal joint (9).
12-146
Back to Top
