TM-9-2320-361-24-1
2-1/2 TON, 6X6, M44A2 SERIES TRUCKS
TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE PART 1 OF 2
AUGUST 2006
TM-9-2320-361-24-1 - Page 1046 of 1176
TM 9-2320-361-24-1
0166 00
0166 00-2
PARKING BRAKE LEVER REPLACEMENT (Contd)
REMOVAL
1.
Release parking brake if applied (refer to TM 9-2320-361-10).
2.
Remove cotter pin (4), washer (3), and clevis pin (15) from cable clevis (12) and parking brake
lever (1). Discard cotter pin (4).
3.
Remove four nuts (6) and bracket (10) from cab floor (9) and two parking brake lever mounting
brackets (7).
NOTE
Assistant will help with step 4.
4.
Remove nut (11), screw (8), and parking lever (1) from cab floor (9).
5.
Remove nut (5), screw (13) and spacer (2) from two parking brake lever mounting brackets (7).
6.
Remove two nuts (14), screws (16), and parking brake lever mounting brackets (7) from parking
lever (1).
INSTALLATION
NOTE
Ensure parking brake lever adjusting knob is turned
counterclockwise to lower link for installation.
1.
Install two parking brake lever mounting brackets (7) on parking brake lever (1) with two
screws (16) and nuts (14). Do not tighten nuts (14).
2.
Install spacer (2) and screw (13) between two parking brake lever mounting brackets (7) and
parking brake lever (1) with nut (5). Tighten nuts (5) and (14) so parking brake lever (1) moves
freely.
NOTE
Assistant will help with step 3.
3.
Install parking brake lever (1) on cab floor (9) with screw (8) and nut (11).
4.
Install bracket (10) on cab floor (9) and two parking brake lever mounting brackets (7) with four
nuts (6).
5.
Connect parking brake lever (1) to cable clevis (12) with clevis pin (15), washer (3), and new cotter
pin (4).
6.
Adjust parking brake lever (TM 9-2320-361-10).
7.
Connect battery ground cable (WP 0126 00).
8.
Remove wheel chocks (TM 9-2320-361-10).
Back to Top
