TM-9-2320-361-24-1
2-1/2 TON, 6X6, M44A2 SERIES TRUCKS
TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE PART 1 OF 2
AUGUST 2006
TM-9-2320-361-24-1 - Page 1152 of 1176
TM 9-2320-361-24-1
0188 00
0188 00-4
REAR HUB AND DRUM MAINTENANCE (Contd)
ASSEMBLY
1.
Install new inner bearing seal (5) and inner bearing (4) on spindle (6).
2.
Install six new wheel studs (10) on hub (11).
3.
Install adapter (1) on hub (11) with eight new lockwashers (9) and screws (8). Tighten screws (8)
81–104 lb-ft (110–141 N
•
m) and install new safety wire (7).
4.
Install hub (11) in drum (16).
5.
Install deflector (2) on adapter (1) with ten new screws (3).
6.
Install inspection cover (15), ten new lockwashers (14), and nuts (13). Tighten nuts (13) 31–39 lb-ft
(42–53 N
•
m).
INSTALLATION
CAUTION
Do not slide hub and drum assembly over threaded end of
spindle, or damage to equipment may result.
1.
Install hub (11) and drum (16) on spindle (6).
CAUTION
Do not slide seal over threaded end of spindle, or damage to seal
may result.
2.
Install outer bearing (17) and new cork gasket (12) in keyway of spindle (6), and install new outer
bearing seal (18) on spindle (6).
3.
Install inner adjusting nut (19) on spindle (6), and adjust wheel bearings (WP 0189 00).
4.
Install new key washer (20) and outer adjusting nut on spindle (6). Bend key washer (20) tabs over
on inner adjusting nut (19) and outer adjusting nut (21).
5.
Install rear wheels (TM 9-2320-361-10) but do not lower.
6.
Install rear axle shaft (WP 0147 00).
7.
Connect battery ground cable (WP 0126 00).
8.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
9.
Check brake adjustment (WP 0168 00).
END OF WORK PACKAGE
6
5
4
3
2
1
11
10
9
8
7
15
14
13
12
18
19
20
21
17
16
Back to Top
