TM-9-2320-361-24-2

2-1/2 TON, 6X6, M44A2 SERIES TRUCKS

TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE PART 2 OF 2

AUGUST 2006

TM-9-2320-361-24-2 - Page 710 of 1144

TM 9-2320-361-24-2

0392 00

0392 00-2

CHEMICAL AGENT ALARM MOUNTING KIT REPLACEMENT (Contd)

REMOVAL

1.

Remove nut (3) and harness receptacle (5) from bracket (2).

2.

Remove three locknuts (10), support (9), three screws (4), and detector unit bracket (1) from left

front fender (8). Discard locknuts (10).

3.

Remove screw (6) and clamp (7) from front fender (8).

4.

Disconnect wire (16) from connector (17).

5.

Remove locknut (11), washer (12), screw (19), harness ground wire (18), ground strap (15), and

washer (14) from right side of turn signal flasher box (13). Discard locknut (11).

6.

Remove four tiedown straps (28) from main wiring harness (27). Discard tiedown straps (28).

NOTE

Assistant will help with steps 7 through 13.

7.

Remove locknut (31), screw (30), and clamp (29) from firewall (32). Discard locknut (31).

8.

Loosen two screws (25) and remove harness (22) from clamps (26).

9.

Remove screw (39) and clamp (38) from rear cab panel (20).

10.

Remove grommet (37) from cab floor hole (36).

11.

Remove two screws (33) and clamps (34) from frame (35).

12.

Remove harness (22) from firewall (32).

13.

Remove two locknuts (21), screws (24), and alarm unit bracket (23) from rear cab panel (20).

Discard locknuts (21).