TM-9-2320-361-34
2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
MAY 1992
TM-9-2320-361-34 - Page 10 of 764
TM 9-2320-361-34
USING YOUR MANUAL: AN EXAMPLE
I
TASK The direct and general support maintenance
mechanic of an M44A2 series vehicle reports that
the engine will not crank. The vehicle has been
assigned to you for repair.
TROUBLESHOOTING STEPS:
1,
2
<
3.
4,
5.
6,
7.
8.
Look at the cover of this manual. You’ll see
chapter/section titles listed from top to bottom
on the right-hand side.
Look at the right edge of the manual. On some
of the pages you’ll see edge indicators (black
bars) that are alined with the chapter/section
bars on the cover. These are the locations of the
chapter/section
in the text.
Look for “SERVICE AND TROUBLE-
SHOOTING INSTRUCTIONS” in the chapter
list on the cover. This is where the
troubleshooting information is located.
Turn to those pages with the edge indicator
matching the black bar for service and
troubleshooting instructions. Page numbers are
also listed next to chapter/section titles.
One of the first pages having service and
troubleshooting instructions edge indicators is
the “MECHANICAL TROUBLESHOOTING
INDEX.”
Look down the list until you find “ENGINE.”
Beneath that heading you will find the
symptoms noted by the maintenance mechanic:
“Engine will not crank.”
Turn to the page indicated: 2-6.
On page 2-6, steps/tests relating to resolving
the problem of “Engine will not crank” are
found.
You inspect the oil pump and find that it is
defective and must be replaced. Paragraph 3-12
is referenced.
The rest of the inspection shows no other cause
for the problem.
Back to Top
