TM-9-2320-361-34
2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
MAY 1992
TM-9-2320-361-34 - Page 5 of 764
TM 9-2320-361-34
●
●
●
●
●
●
●
●
●
●
●
d
WARNING SUMMARY
(Contd)
Derrick tube is heavy. Provide adequate support for derrick tube during removal and installation over
rack bar. Failure to do so may result in injury or death to personnel.
Ensure auger rack bar is balanced on chain during removal and installation. Failure to do so may cause
auger rack bar to slip from chain, causing injury to personnel or damage to equipment.
Before removing horizontal or vertical leveling worm gear housing, place supports under intermediate
case to prevent case from turning. If intermediate case turns, injury to personnel and/or damage to
equipment may result.
Be prepared to support clutch and brake otherwise it may fall and cause injury to personnel and/or
damage to equipment.
Use lifting device and chains during repair of winches to prevent injury to personnel.
Eye protection is required when using wire brush for cleaning. Failure to do so may result in injury to
personnel.
Allow time for heater to cool before removing from test equipment. Failure to do so may result in injury
to personnel or damage to equipment.
Eye protection is required when working with hydraulic hoses. Failure to wear eye protection may result
in injury to personnel.
Eye protection is required when removing plugs. Failure to wear eye protection may result in injury to
personnel.
Eye protection must be worn during welding procedures. Failure to wear eye protection may result in
injury to personnel.
Welding procedures may produce poisonous fumes. Perform welding in well-ventilated areas. Failure to
do so may result in injury to personnel.
Back to Top
