TM-9-2320-362-14-P
TRUCK UTILITY: S250 SHELTER CARRIER, 4X4, M1037 FOR TRAFFIC JAM AN/TLQ-17A(V)3 (HMMWV)
TECHNICAL MANUAL; OPERATOR, UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST FOR ELECTRICAL ENVIRONMENTAL SYSTEM (EES)
APRIL 1992
TM-9-2320-362-14-P - Page 16 of 353
T
M
9-2320-362-14&P
NOTE
Warnings, cautions,
and notes provide supplemental
information.
Warnings
-
Indicate conditions, practices, or procedures which
must be observed to avoid personnel injury, loss of life, or
long-term health hazard.
Cautions
-
Indicate conditions, practices, or procedures which
must be observed to avoid damage to equipment or destruction of
equipment.
Notes
-
Include essential information of special importance,
interest,
or aid in job performance which should be remembered
and would be otherwise difficult to find or incorporate into the
text.
4. At the end of the procedure,
“FOLLOW-ON TASKS” will list those
additional tasks that must be performed to complete the procedure.
The Follow-on Tasks for tachometer replacement are:
●
Connect battery ground cable (TM 9-2320-280-20).
●
Start engine (TM 9-2320-280-10) and check operation of
tachometer 650 RPM ± 25 RPM at idle.
e.
Refer to the example pages for para.
3-18, Tachometer Replacement, as
we review the following points:
1. Modular Text:
Both pages of text and illustrations are to be used
together.
This manual was designed so that the two pages would be
visible at once,
making part identification and procedure sequence
easy to follow.
2. Initial Setup:
Outlines task conditions.
3. Illustrations:
An exploded diagram of the component shows part
locations,
attachments,
and spatial relationships.
Cutaway views
(part of the component
“erased”) show the location and orientation
of screws and attachments.
f.
Your manual is easy to use once you understand its design. We hope it
will encourage you to use your TM more often as an aid to maintenance
support for the components of the EES kit.
xii
Back to Top
