TM-9-2320-362-14-P
TRUCK UTILITY: S250 SHELTER CARRIER, 4X4, M1037 FOR TRAFFIC JAM AN/TLQ-17A(V)3 (HMMWV)
TECHNICAL MANUAL; OPERATOR, UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST FOR ELECTRICAL ENVIRONMENTAL SYSTEM (EES)
APRIL 1992
TM-9-2320-362-14-P - Page 15 of 353
TM 9-2320-362-14&P
●
Tools and Special Tools:
Those tools, tool kits, and special
tools needed to complete a task.
If no tools, tool kits, or
special tools are required,
this heading will not be used.
If you don’t have one of these special tools, requisition it
(before starting the task) using the data supplied in the RPSTL,
appendix D, for your level of maintenance.
Special tools are
located in section III.
●
Materials/Parts:
This heading lists only mandatory replacement
materials or parts (gaskets, “O” rings, sealant, etc.). To
replace other unserviceable parts, refer to appendix D for
requisition data.
If no mandatory replacement materials/parts
are required,
this heading will not be used.
●
Personnel Required:
The number of personnel needed to perform a
task.
If only one mechanic is needed, this heading will not be
used.
NOTE
If you think that you need more help to adequately
or safely complete a task, perhaps as the result of
unusual conditions, etc.,
alert your supervisor and
ask for help.
●
Manual References:
Those TMs needed to complete the task.
If no
other TMs are needed, this heading will not be used.
●
Equipment Conditions:
Notes the conditions that must exist
before starting the task.
If none are required, this heading
will not be used.
For the tachometer replacement, the engine
should be shut off before we can start the task.
If not already
done, follow the procedure for engine shut off in TM 9-2320-280-
10, before proceeding with this task.
●
General Safety Instructions:
Summarizes all safety warnings for
the maintenance task.
If none are required, this heading will
not be used.
3. A step by step maintenance procedure follows the “INITIAL SETUP”
and gives detailed instructions for the procedure.
These
instructions give the part’s general location and name and action
performed.
In the example,
tachometer replacement - a. Removal,
step 1 is :
“Remove seven screws (2), lockwashers (3), and washers
(1) from tach/hourmeter box cover (4).
Discard lockwashers (3).”
Note that the numbers in parenthesis correspond to the part’s
callout number in the accompanying illustration.
xi
Back to Top
