TM 9-2320-365-20-1
VOLTAGE TEST
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle.
Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
WARNING
Change 2
2-993
(1) Remove personnel heater for access
(para 18-9).
(2) Disconnect connector J913 from connector
P913.
(3) Set multimeter to volts DC.
(4) Connect positive (+) probe of multimeter to
connector J913-5.
(5) Connect negative (-) probe of multimeter to
ground.
(6) Position master power switch to on
(TM 9-2320-365-10) and note reading on
multimeter.
(7) If 24 VDC is not present, repair wire 1925
(para 2-40) or replace WTEC III dashboard
cable assembly (para 7-11).
(8) Position master power switch to off
(TM 9-2320-365-10).