TM 9-2320-365-20-1
TM 9-2320-365-20-1
TM 9-2320-365-20-1
TM 9-2320-365-20-1
TM 9-2320-365-20-1
2-1051
2-1051
2-1051
2-1051
2-1051
CONTINUITY TEST
(1)
Raise cab (TM 9-2320-365-10).
(2)
Disconnect connector P42 from ether sensor
connector.
(3)
Connect jumper wire to connector P42-2.
(4)
Set multimeter to ohms.
(5)
Connect positive (+) probe of multimeter to
connector P31-2.
(6)
Connect negative (-) probe of multimeter to
jumper wire and note reading on multimeter.
(7)
If continuity is not present, repair wire 1402
(para 2-40) or replace engine control cable
assembly (para 7-72).