TM-9-2320-365-20-2

M1078 SERIES, 2 1/2-TON, 4 X 4, LIGHT MEDIUM TACTICAL VEHICLES (LMTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 2 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-365-20-2 - Page 355 of 1432

RESISTANCE TEST

TM 9-2320-365-20-2

Change 1

2-1409

Table 2-23.

Transmission Solenoid F and G

Resistance Test Points

Sub

Code

Affected

Solenoid

Connector

P119 High

Connector

P119 Low

21

26

F

N

F

K

H

A

(1)

Set multimeter to ohms.

(2)

Connect positive (+) probe of multimeter

to connector P119.

Refer to Table 2-23.

Transmission Solenoid F and G Resistance

Test Points.

(3)

Connect negative (-) probe of multimeter to

connector P119 and note reading on

multimeter.

Refer to Table 2-23.

Transmission Solenoid F and G Resistance

Test Points.

(4)

Connect negative (-) probe of multimeter to

all other pins in connector P119, one at a

time, and note reading on multimeter.

(5)

Connect negative (-) probe of multimeter to

ground and note reading on multimeter.

(6)

If good resistance is not noted in step 3, or

continuity is present in step 4 or step 5,

replace WTEC II cab transmission harness

(para 7-86).

(7)

If good resistance is noted in step 3, and

continuity is not present in step 4 or step

5, replace WTEC II TEPSS (para 8-2).

(8)

Connect connector P119 to connector J119.

(9)

Position front grille on cab with washer and

screw.

(10)

Position two washers and screws in front

grille.

(11)

Tighten screw to 48-60 lb-in. (5-7 N·m).

(12)

Tighten two screws to 24 lb-in. (3 N·m).

(13)

Connect connectors J114 and J115 to

WTEC II TEPSS.

(14)

Install instrument panel assembly (para 7-15).

(15)

Clear diagnostic codes (para 8-4).