(1)
Set multimeter to ohms.
(2)
Connect positive (+) probe of multimeter
to connector P115-17.
(3)
Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(4)
Connect positive (+) probe of multimeter
to connector P115-32.
(5)
Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(6)
If resistance noted in step 3 or step 5 is
higher than 0.5 ohms, repair wire 143 (para
2-40) or replace WTEC III dashboard cable
assembly (para 7-11).
(7)
Connect connector P115 to WTEC III
transmission ECU.
(8)
Connect connector clamp on connector
P115.
RESISTANCE TEST
Change 1
2-1585
TM 9-2320-365-20-2