TM 9-2320365-20-3
7-286
Change 2
7-72.
ENGINE CONTROL CABLE ASSEMBLY REPLACEMENT (CONT)
(6)
Install clamps (11 and 12) on engine control cable
assembly (1).
(7)
Install clamps (11 and 12) on clamps (13 and 14) with
two screws (15) and self-locking nuts (16).
(8)
Connect connector P41 (17) to coolant temperature
gage sensor connector (18).
(9)
Connect connector clamp (19) on connector P41 (17).
(10) Apply electrical tape to TL110 (20).
NOTE
•
Perform step (10) if replacing alternator
N1506-1 (12420852) with alternator
N1509-1 (12422863).
•
Install plastic cable ties to TL110 and tie
wire away from alternator.