TM-9-2320-365-20-3

M1078 SERIES, 2 1/2-TON, 4 X 4, LIGHT MEDIUM TACTICAL VEHICLES (LMTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 3 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-365-20-3 - Page 672 of 1268

TM 9-2320-365-20-3

8-8. WTEC III TRANSMISSION CONTROLS INITIAL INSTALLATION (CONT)

NOTE

Reference points are from inside passenger

side dashboard.

(11) Measure and mark a line 2.0 in. (5 cm) from point A to

point B in dashboard (10).

NOTE

Position WTEC III transmission ECU in

dashboard with mounting tabs down.

(12) Position WTEC III transmission ECU (11) in dashboard

(10) with single mounting tab over matchmark.

CAUTION

Do not position WTEC III transmission ECU

on weldnuts in dashboard. Failure to comply

may result in damage to equipment.

(13) Match mark mounting tabs on WTEC III transmission

ECU (11) with centerpunch.

(14) Remove

WTEC

III

transmission

ECU

(11)

from

dashboard (10).

WARNING

Wear goggles when drilling metal. Failure

to

comply

may

result

in

injury

to

personnel.

(15) Drill a pilot hole at centerpunch points marked in step

(13).

(16) Enlarge three pilot holes in step (15) to 0.315 in. (0.8

cm).

(17) Install WTEC III transmission ECU (11) under dashboard

(10) with three washers (16), screws (17), washers (18),

and nuts (19).

8-28