TM-9-2320-365-20-4

M1078 SERIES, 2 1/2-TON, 4 X 4, LIGHT MEDIUM TACTICAL VEHICLES (LMTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 4 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-365-20-4 - Page 535 of 968

TM 9-2320-365-20-4

Change 2

16-487

16-74.

LATCH AND CAB LATCH BRACKETS REPLACEMENT

This task covers:

a. Latch Bracket Removal

b. Latch Bracket Installation

c. Cab Latch Bracket Removal

d. Cab Latch Bracket Installation

INITIAL SETUP

Equipment Conditions

Engine shut down (TM 9-2320-365-10).

Tools and Special Tools

Tool Kit, Genl Mech (Item 46, Appendix C)

Wrench, Torque, 0-175 lb-ft (Item 58, Appendix C)

Cab Support Tool (Item E-4, Appendix E)

Materials/Parts

Sealing Compound (Item 68.3, Appendix D)

Nuts, Self-Locking (2) (Item 149, Appendix G)

Personnel Required

(2)

a. Latch Bracket Removal.

(1)

Raise cab (TM 9-2320-365-10).

(2)

Install cab support tool on engine rear lifting eye

(1).

(3)

Lower cab until cab rests on cab support tool (TM

9-2320-365-10).

(4)

Remove three bolts (2) and washers (3) from latch

bracket (4).

NOTE

Perform step (5) on vehicles 0001 through 7167.

(5)

Remove two self-locking nuts (5), screws (6),spacers

(7), washers (8), and latch bracket (4) from cab (9).

Discard self-locking nuts and spacers.

NOTE

Perform step (6) on vehicles 7168 and higher.

(6) Remove two self-locking nuts (5), screws (6),

washers (8), and latch bracket (4) from cab (9).

Discard self-locking nuts.