TM-9-2320-365-20-4
M1078 SERIES, 2 1/2-TON, 4 X 4, LIGHT MEDIUM TACTICAL VEHICLES (LMTV)
TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 4 OF 5
FEBRUARY 2006
CHANGE 3
TM-9-2320-365-20-4 - Page 567 of 968
TM 9-2320-365-20-4
Change 2
17-19
17-5.
11K SELF-RECOVERY WINCH (SRW) CABLE REPLACEMENT/REPAIR
This task covers:
a.
Removal
b.
Spelter Socket Removal
c.
Spelter Socket Installation
d.
Installation
e.
Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
11K SRW cable payed-out completely from front of
vehicle (TM 9-2320-365-10).
Engine shut down (TM 9-2320-365-10).
Tools and Special Tools
Tool Kit, Genl Mech (Item 44, Appendix C)
Gloves, Welder's (Item 14, Appendix C)
Goggles, Industrial (Item 15, Appendix C)
Grease, Wire Rope-Exposed Gear (Item 23.1,
Appendix-D)
Wire, Non-Electrical (Item 72, Appendix D)
Tool and Special Tool (cont)
Tape, Duct (Item 67, Appendix-D)
Adhesive (Item 10.1, Appendix-D)
Spelter Socket Resin (Item 65.3, Appendix-D)
Vice, Machinist (Item 48, Appendix-C)
Frame, Hand, Hacksaw (Item 9.1, Appendix-C)
Blade, Hand, Hacksaw (Item 3.1, Appendix-C)
Personnel Required
(3)
a. Removal.
(1)
Remove cable wedge (1) and 11K SRW cable (2)
from flange (3).
(2)
Pull 11K SRW cable (2) from flange (3).
(3)
Remove 11K SRW cable (2) from drum (4).
WARNING
•
Wear leather gloves at all times when
handling cable.
Do not allow cable to
slide through hands even with gloves on.
Broken wires may cause injury.
Failure to
comply may result in injury to personnel.
•
Wear appropriate eye protection when
working
under
vehicle
due
to
the
possibility of falling debris.
Failure to
comply may result in injury to personnel.
Back to Top
