TM 9-2320-365-20-4
Change 2
17-20.1
c. Spelter Socket Installation.
(1)
Match mark 2.5 in (63.5 mm) down from end of
cable (1).
(2)
Wrap wire (2) around cable (1) at match mark until
1 in. (25 mm) wide coil of wire is placed on cable.
(3)
Remove tape from end of cable (1).
(4) Separate strands of wire (3) at end of cable (1) until
wire reaches top edge of wrapped wire (2).
(5) Fan separated wires (3) evenly on end of cable (1).
CAUTION
Cut out any fibers or plastic materials in
separate strands of wire. Failure to comply
may result in inability of resin to bound to
cable end.