TM-9-2320-365-34-2

M1078 SERIES, 2 1/2-TON, 4 X 4, LIGHT MEDIUM TACTICAL VEHICLES (LMTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; VOLUME NO. 2 OF 2

AUGUST 2005

CHANGE 2

TM-9-2320-365-34-2 - Page 126 of 1414

TM 9-2320-365-34-2

3-8. CRANKSHAFT FRONT SEAL REPLACEMENT (CONT)

WARNING

Wear appropriate eye protection when

drilling holes.

Failure to comply may

result in injury to personnel.

(5) Drill three equally spaced holes in crankshaft front seal

(10).

(6) Remove crankshaft front seal (10) from crankshaft (8).

Discard crankshaft front seal.

b. Installation.

CAUTION

Crankshaft front seal must be installed with

shipping sleeve in place. Failure to comply

may result in damage to equipment.

(1) Install crankshaft front seal (1) on crankshaft (2).

(2) Position seal installer and plate (3), on crankshaft (2)

with four washers (4) and screws (5).

NOTE

Front seal is properly seated when recessed

into front housing 0.08-0.12 in. (0.20-0.30

cm).

(3) Measure distance from surface of crankshaft front seal

to surface of front housing.

(4) Tighten four screws (5) on plate (3).

3-78