TM-9-2320-365-34-2

M1078 SERIES, 2 1/2-TON, 4 X 4, LIGHT MEDIUM TACTICAL VEHICLES (LMTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; VOLUME NO. 2 OF 2

AUGUST 2005

CHANGE 2

TM-9-2320-365-34-2 - Page 897 of 1414

TM 9-2320-365-34-2

Change 2

16-40.3

(10) Remove drive shaft (10) from frame (11).

(11) Position universal joint (12) on yoke (13) with two

bearing cups (14) and four screws (15).

(12) Tighten four screws (15).

WARNING

CAUTION

NOTE

Step (10) requires the aid of an assistant.

NOTE

•

When correct torque is reached, bearing

cap screw small hex head will brake off.

•

Perform the following step on kits equipped

with screws P/N C5 H5 24-39.

Do not use steel hammers to seat

bearing cups in drive yokes.

Failure to

comply may result in injury to personnel

or damage to equipment.

Check bearing cups to ensure all needle

bearings are in place prior to installation.

Replace bearing cups if needle bearings are

missing or out of place.

Failure to comply

may result in damage to equipment.

NOTE

•

Wipe end of yoke bearing cores prior to

installation.

•

There are two types of bearing cup, those

with tabs and those without.

Perform the

following step on bearing cups not

equipped with tabs.