TM-9-2320-366-10-2
M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)
TECHNICAL MANUAL; OPERATOR’S INSTRUCTIONS; VOLUME NO. 2 OF 2
AUGUST 2005
CHANGE 2
TM-9-2320-366-10-2 - Page 559 of 930
TM 9-2320-366-10-2
Table 3-2. Troubleshooting (Cont)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
e55.
FRONT AND REAR HAZARD LIGHTS DO NOT ILLUMINATE (CONT).
(i)
Position hazard lights switch to off (para 2-27c).
(j)
Position main light switch to OFF (para 2-27c).
e56.
FRONT AND REAR TURN SIGNALS DO NOT ILLUMINATE.
Step 1. Check operation of all vehicle lights (para 2-27c).
If either light does not illuminate, notify Unit Maintenance.
Step 2. Check circuit breaker (CB74) in PDP to see if it is tripped.
(a)
Remove PDP cover (para 3-17a).
(b)
Position main light switch to OFF (para 2-27c).
(c)
If circuit breaker is tripped, push in to reset.
(d)
Position main light switch to SER DRIVE (para 2-27c).
(e)
Check circuit breaker to see if it tripped. If circuit breaker is tripped, notify Unit Maintenance.
(f)
Position main light switch to OFF (para 2-27c).
(g)
Install PDP cover (para 3-17b).
(h)
If front and rear turn signals still do not illuminate, notify Unit Maintenance.
e57.
LEFT OR RIGHT FRONT TURN SIGNAL DOES NOT ILLUMINATE.
Step 1. Check operation of all vehicle lights (para 2-27c).
If either light does not illuminate, notify Unit Maintenance.
Step 2. Check circuit breaker (CB74) in PDP to see if it is tripped.
(a)
Remove PDP cover (para 3-17a).
(b)
Position main light switch to OFF (para 2-27c).
(c)
If circuit breaker is tripped, push in to reset.
(d)
Position main light switch to SER DRIVE (para 2-27c).
(e)
Check circuit breaker to see if it tripped. If circuit breaker is tripped, notify Unit Maintenance.
(f)
Position main light switch to OFF (para 2-27c).
(g)
Install PDP cover (para 3-17b).
(h)
If left or right front turn signal still does not illuminate, notify Unit Maintenance.
Change 1
3-59
Back to Top
