TM-9-2320-366-20-1
M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)
TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5
FEBRUARY 2006
CHANGE 3
TM-9-2320-366-20-1 - Page 1095 of 1824
Change 1
2-604.163
TM 9-2320-366-20-1
VOLTAGE TEST
Remove plastic cable ties as required.
(1) Disconnect connector P88 from RH rear
side marker light connector.
(2) Set multimeter to volts DC.
(3) Connect positive (+) probe of multimeter
to connector P88.
(4) Connect negative (-) probe of multimeter to
ground.
(5) Position main light switch to SER DRIVE
(TM 9-2320-366-10-1) and note reading
on multimeter.
(6) Position main light switch to OFF (TM
9-2320-366-10-1).
(7) If 12 VDC is not present, repair wire 489
from splice E15 to splice E17 (para 2-45)
and go to step 9 of this fault if required
or replace M1085/M1096 rear lights cable
assembly (para 7-84) and go to step 1 of
this fault.
(8) If 12 VDC is present, repair wire 489 from
connector P89 to splice E17 (para 2-45)
and go to step 46 of this fault if required
or replace M1085/M1096 rear lights cable
assembly (para 7-84) and go to step 1
of this fault.
Install plastic cable ties as required.
(9) Connect RH rear side marker
light connector to
connector P88.
(10) Connect RH rear marker light connector
to connector P89.
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle.
Jewelry can catch on equipment and
cause injury or short across electrical circuits, or
cause severe burns or electrical shock.
CAUTION
Use care when testing electrical connectors not
to bend connector pins or damage connector
sockets with multimeter probes.
Failure to
comply may result in damage to equipment.
Inspect connector pins/sockets for damage,
corrosion, and serviceability.
Check that
connector pins are not pushed back and
are capable of making good contact.
NOTE
NOTE
NOTE
Back to Top
