TM-9-2320-366-20-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-1 - Page 1103 of 1824

CONTINUITY TEST

TM 9-2320-366-20-1

Change 1

2-604.171

(1) Disconnect batteries (para 7-57).

(2) Remove PDP cover (para 16-2).

(3) Remove three screws and washers from

PDP.

(4) Remove three screws from PDP.

(5) Lift PDP outward to gain access.

(6) Disconnect connector P51 from connector

J51.

(7) Set multimeter to ohms.

(8) Connect positive (+) probe of multimeter

to connector J51 pin 7.

(9) Connect negative (-) probe of multimeter to

terminal board TB1 position 11 and note

reading on multimeter.

(10) If continuity is not present, repair wire 489

from terminal board TB1 position 11 to

connector J51 pin 7 (para 2-45) or replace

WTEC II dashboard cable assembly

(para 7-10) or WTEC III dashboard cable

assembly (para 7-11).

Inspect connector pins/sockets for damage,

corrosion, and serviceability.

Check that

connector pins are not pushed back and

are capable of making good contact.

Use care when testing electrical connectors not

to bend connector pins or damage connector

sockets with multimeter probes.

Failure to

comply may result in damage to equipment.

CAUTION