TM-9-2320-366-20-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-1 - Page 1105 of 1824

CONTINUITY TEST

Change 1

2-604.173

TM 9-2320-366-20-1

(1) Disconnect connector P52M from

connector J52M.

(2) Set multimeter to ohms.

(3) Connect positive (+) probe of multimeter

to connector P51 socket 7.

(4) Connect negative (-) probe of multimeter to

connector P52M socket 3 and note reading

on multimeter.

(5) If continuity is not present, repair wire 489

from connector P51 socket 7 to P52M

socket 3 or replace M1088 rear lights

cable assembly (7-104).

(6) Connect connector J52M to connector

P52M.

(7) Connect connector J51 to connector P51.

(8) Install PDP on dashboard with three

screws.

(9) Install three washers and screws in PDP.

(10) Install PDP cover (para 16-2).

(11) Connect batteries (para 7-57).

Use care when testing electrical connectors not

to bend connector pins or damage connector

sockets with multimeter probes.

Failure to

comply may result in damage to equipment.

CAUTION

Inspect connector pins/sockets for damage,

corrosion, and serviceability.

Check that

connector pins are not pushed back and

are capable of making good contact.

NOTE